Activedumpsnet Logo
How did 4G Lampsite achieve "no point increase" when transforming the NR room into a 3.5Ghz NR room?
NSA networking needs to modify the original EPS, in addition to adding NR base stations, what upgrades need to be made?
What is the MML command used by gNodeB to add CI port configuration?
In the Decore selection network of the NSA core network, the service MME assigns DCN? to UE based on which information in the UE subscription information
What data configuration tools can gNodeB use to complete the site opening?
Co-MPT means that each standard is deployed on the same BTS Node and is uniformly connected to OMC management.
Under NSA networking, which of the following commands can be used to check whether the S1-U interface is normal?
What is the fiber pulling capacity between AAU and BBU using eCPRI schemes
Add gNodeB identity Which of the following MML commands is used?
Which is the choice of clock synchronization mode for C-Band low-frequency networking gNodeB base station?
3GPP Release Version 15 does not describe which 5G application scenario?
What is IMT-2020's vision for peak rates for 5G networks?
gNodeB requires two IP addresses to the same destination with the same destination mask and the same route priority cannot be the same.
What are the configuration modules that differ between the gNodeB data configuration and the LTE data configuration MML command?
Under the EN-DC architecture, eNodeB/gNodeB only supports configuring X2 fingers based on EndPoint.
Which of the following parameters is related to the frequency domain position of the PBCH DMRS?
The CPE Pro admin page supports multiple users logging in at the same time.
Compared to BBU5900 and 3910, which slot has not changed the actual position of the slot number?
In 5G base stations, which of the following is correctly interpreted regarding the ".ecf" suffix?
In the inter-station DC scheme, the X2 interface can be used to achieve transmission intercommunication between LTE and NR sites, but how long does the transmission delay take?
When gNodeB adds NR RF unit AAU, which item should be selected for its "RF unit working standard"?
In the Sub 3G band, the maximum number of wave speeds for SSBs in NR is 16.
When verifying the uplink 5G Only offload effect of the NSA network, under normal circumstances, only the NR side has uplink traffic, and the rate is stable, while the LTE side tracks no rate
Which of the following signals reflects the coverage of the NR network uplink?
In the scenario of NSA networking, gNodeB's S1-U interface is self-built, which objects are unnecessary?
The ratio of upstream and downstream subframes in 5G RAN2.0 gNodeB cells supports SA5.
If the NR base station cannot load the new BTS5900 base station configuration data at the remote end, which of the following solutions can be used for near-end data configuration?
When port negotiation for a X2 interface SCTP link, the local and peer can share the same port number.
What are the supported subcarrier intervals for 5G RAN2.0 gNodeB cells?
If in order to make the BBU support more NR cells, which of the following boards needs to be added?
If the main control board UMPT uses a 10Gbps optical module when the NR base station is turned on, the ETHPORT of GTRANSPARA must be configured to 10Gbps and cannot be configured to slow down.
Which of the passive WDM schemes for CRAN fronthaul is correctly described?