Labour Day Special Limited Time Flat 70% Discount offer - Ends in 0d 00h 00m 00s - Coupon code: 70spcl

HP HPE6-A72 Aruba Certified Switching Associate Exam Exam Practice Test

Page: 1 / 9
Total 88 questions

Aruba Certified Switching Associate Exam Questions and Answers

Question 1

Which two options are the Layer 2 protocols? (Choose two.)

Options:

A.

802.1Q

B.

IPSec

C.

STP

D.

RIP

E.

802.11af

Question 2

What is the correct description of a Multi-Layer Switch?

Options:

A.

a switch with Layer 3 routing capabilities but lacks any Layer 1 features as a consequence

B.

any switch that supports PoE, LLDP-MED and Flow Control

C.

has all the functionality of a Layer 2 switch and most of the functionality of a Layer 3 router

D.

multi-Layer refers specifically to using chassis switches with several line cards over stack port switches

Question 3

You need to remote into an AOS-CX switch using SSH in order to update the management IP address for future connections. Unfortunately, you mis-configured the IP address and are now locked out of the switch.

What command could you have issued before making changes that would have recovered the original switch configuration after ten minutes?

Options:

A.

checkpoint rollback 10

B.

checkpoint auto 10

C.

checkpoint auto confirm 10

D.

boot system secondary 10

Question 4

What are two methods for remotely managing an Aruba AOS-CX switch? (Choose two.)

Options:

A.

SNMPv2c

B.

HTTPS

C.

USB-C console

D.

Telnet

E.

SSH

Question 5

Which statement is true regarding modern switching requirements?

Options:

A.

Most older legacy switches had high port bandwidth utilization and were future proof designed to meet today's power-over-Ethernet needs.

B.

Requirements for PoE are normally addressed using AC to DC power adapters. Concerns for port security for IoT devices are usually addressed using default wired encryption that all 802.3 Ethernet switches provide.

C.

While APs are common, most clients are still docked and only require traditional wired connections with only the occasional dedicated PoE switch to provide power for the low number of devices needed.

D.

Clients tend to prefer wireless connections, raising the need for PoE port access. There is also a growing amount of IoT devices that require security and port authentication options.

Question 6

Which two port characteristics must match between LAG interfaces? (Choose two.)

Options:

A.

Port number

B.

Duplex

C.

Member ID

D.

Media type

E.

Chassis number

Question 7

The section in blue can be ignored.

SW1(config)# interface 1/1/1-1/1/2

SW1(config-if-<1/1/1-1/1/2)# vlan access 2

SW1(config-if-<1/1/1-1/1/2)# exit

SW1(config)# interface 1/1/11-1/1/17

SW1(config-if-<1/1/11-1/1/17)# vlan access 17

SW1(config-if-<1/1/11-1/1/17)# exit

After completing the above commands, what is the expected output of show vlan with no other vlan commanded having been added?

Question # 7

Options:

A.

Option A

B.

Option B

C.

Option C

D.

Option D

Question 8

Refer to the exhibit.

Question # 8

All four switches in the diagram have been configured with the region name "Aruba1".

What two other MSTP configurations must match for switches within the same MST region? (Choose two.)

Options:

A.

MST region type

B.

MST Bridge ID

C.

MST version number

D.

MST revision number

E.

MST VLAN to instance mapping

Question 9

Which two types of routes can be found in the IP routing table of an Aruba AOS-CX switch? (Choose two.)

Options:

A.

Local

B.

EIGRP

C.

BGP

D.

ISIS

E.

RIPng

Question 10

Aruba Access Points tunnel traffic in a campus to the Mobility Controller using which protocol?

Options:

A.

Control and Provisioning of Wireless Access Points (CAPWAP)

B.

Generic Routing Encapsulation (GRE)

C.

Lightweight Access Point Protocol (LWAPP)

D.

Process Application Programming Interface (PAPI)

Question 11

The customer has 778 developers testing computer games on the network.

Which two actions resolve Broadcast storms? (Choose two.)

Options:

A.

Manually disable the redundant link to immediately resolve the impacted portion of the network.

B.

Utilize Spanning Tree to dynamically disable all redundant links in a segment.

C.

Setting switch ports to half-duplex will resolve Broadcast storms using Carrier Sense Multiple-Access Collision Detection (CSMA/CD).

D.

Enable single Area Open Shortest Path First (OSPF) on all Layer 2 switches, but do not enable routing.

E.

Utilize Spanning Tree to dynamically block Designated ports in addition to Alternate ports.

Question 12

Click on the colored box that corresponds with the line that best represents Unicast traffic flow.

Question # 12

Options:

Question 13

Which two commands will save the running-config so that changes will be loaded automatically on the next reboot? (Choose two.)

Options:

A.

write memory

B.

save

C.

copy config config1 config startup-config

D.

copy running-config startup-config

E.

copy running-config checkpoint boot-config

Page: 1 / 9
Total 88 questions