Redeem Your Black Friday Code: 75% Off All Exam Bundles! Use coupon code below! - Ends in 0d 00h 00m 00s - Coupon code: discactive

Cisco 300-120 Implementing Cisco Wireless Advanced Solutions (300-120 WLSI) v1.2 Exam Practice Test

Page: 1 / 11
Total 105 questions

Implementing Cisco Wireless Advanced Solutions (300-120 WLSI) v1.2 Questions and Answers

Question 1

What is the difference between PIM sparse mode and PIM dense mode?

Options:

A.

Sparse mode supports only one switch. Dense mode supports multiswitch networks.

B.

Sparse mode floods. Dense mode uses distribution trees.

C.

Sparse mode uses distribution trees. Dense mode floods.

D.

Sparse mode supports multiswitch networks. Dense mode supports only one switch.

Question 2

An engineer wants to upgrade the APs in a Cisco FlexConnect group. To accomplish this upgrade, the FlexConnect AP Upgrade setting will be used. One AP of each model with the lowest MAC address in the group must receive the upgrade directly from the controller. Which action accomplishes this direct upgrade?

Options:

A.

Remove the APs from the group.

B.

Reboot all APs before the upgrade.

C.

Allocate the master APs to different groups.

D.

Do not set any master APs.

Question 3

An engineer is planning an image upgrade of the WLC, and hundreds of APs are spread across remote sites with limited WAN bandwidth. The engineer must minimize the WAN utilization for this upgrade. Which approach must be used for the AP image upgrade?

Options:

A.

Predownload the new code to the APs.

B.

Use the Smart AP image upgrade feature.

C.

Allow the APs to download their code after WLC reboot.

D.

Execute parallel TFTP code upgrade on the APs via SSH.

Question 4

Which feature on the Cisco Wireless LAN Controller must be present to support dynamic VLAN mapping?

Options:

A.

FlexConnect ACL

B.

VLAN name override

C.

CCKM/OKC

D.

AAA override

Question 5

A corporation has a wireless network in which all APs are configured in FlexConnect mode. The WLC has a data WLAN and a VoWiFi WLAN, and both SSIDs are centrally switched. Which QoS configuration must be implemented so that wireless packets maintain their markings across the wired and wireless networks?

Options:

A.

IPP

B.

CoS

C.

DSCP

D.

WMM UP

Question 6

Refer to the exhibit A network engineer must deploy a configuration to a Cisco Catalyst 9800 WLC to prevent a FlexConnect AP from allowing wireless clients to connect when its Ethernet connection is down Which code snippet must be added to the box in the code to complete the configuration?

Question # 6

Question # 6

Options:

A.

Option A

B.

Option B

C.

Option C

D.

Option D

Question 7

Refer to the exhibit. A network administrator must use the webhook feature in Cisco DNA Catalyst Center to receive notifications for multiple events related to the AP - Usage and Client Breakdown report. The external service handling these notifications is located at the callback URL https://example.com/webhook and has the requirements:

Which code snippet must be placed onto the box in the code to complete the Python script that configures the webhook?

Question # 7

Question # 7

Options:

A.

Option A

B.

Option B

C.

Option C

D.

Option D

Question 8

A wireless engineer must implement a corporate wireless network for a large company in the most efficient way possible. The wireless network must support 32 VLANs for 300 employees in different departments. Which solution must the engineer choose?

Options:

A.

Configure a second WLC to support half of the APs in the deployment.

B.

Configure one single SSID and implement Cisco ISE for VLAN assignment according to different user roles.

C.

Configure different AP groups to support different VLANs, so that all of the WLANs can be broadcast on both radios.

D.

Configure 16 WLANs to be broadcast on the 2.4-GHz band and 16 WLANs to be broadcast on the 5.0-GHz band.

Question 9

A network engineer recently deployed Cisco Catalyst Center (formerly DNA Center) to a customer site. The customer is being flooded with alarms for wireless clients that fail AAA authentication. What is the path to disable the alarm in the Cisco Catalyst Center user interface?

Options:

A.

Assurance > Manage > Sensors

B.

Assurance > Manage > Intelligent Capture Settings

C.

Assurance > Manage > Issue Settings

D.

Assurance > Manage > Health Score Settings

Question 10

A Cisco WLC has been added to the network and Cisco ISE as a network device, but authentication is failing. Which configuration within the network device configuration should be verified?

Options:

A.

SNMP RO community

B.

device interface credentials

C.

device ID

D.

shared secret

Question 11

When the Cisco FlexConnect AP Image Upgrade feature is used, APs must communicate with each other to distribute the image. Which two elements are required for this feature to work when the APs are on different subnets? (Choose two.)

Options:

A.

Configure routing so that the APs can reach the core switch.

B.

Disable peer-to-peer blocking.

C.

Connect the APs to the same switch or switch stack.

D.

Configure routing and switching between APs on different subnets.

E.

Allow communication between the APs through the firewall.

Question 12

On a Cisco Catalyst 9800 Series Wireless Controller, an engineer wants to prevent a FlexConnect AP from allowing wireless clients to connect when its Ethernet connection is nonoperational. Which command set prevents this connection?

Options:

A.

config terminal

wireless flexconnect profile [profile name]

ethernet-fallback-enable

end

B.

config terminal

wireless flexconnect profile [profile name]

fallback-radio-shut

end

C.

config terminal

wireless profile flex [profile name]

fallback-radio-shut

end

D.

config terminal

wireless profile flex [profile name]

ethernet-fallback-enable

end

Question 13

Where is a Cisco OEAP enabled on a Cisco Catalyst 9800 Series Wireless Controller?

Options:

A.

RF Profile

B.

Flex Profile

C.

Policy Profile

D.

AP Join Profile

Question 14

Refer to the exhibit. A network administrator must automate notifications for Security Advisories Data reports on the Cisco Catalyst Center v2.3.7 using the Report notification feature. Preferring a programmable approach over UI/CLI, the administrator decides to create a webhook via the Cisco DNA Center API to send real-time HTTP notifications to an external application. The webhook URL https://example.com/webhook uses HTTPS with a self-signed certificate, which requires a specific configuration in the payload to ensure the webhook functions correctly. Which code snippet must be placed onto the box in the code to complete the Python script that configures the webhook to use the self-signed certificate to extract the Security Advisories Data report?

Question # 14

Options:

A.

Option A

B.

Option B

C.

Option C

D.

Option D

Question 15

In a Cisco WLAN deployment, it is required that all Aps from branch1 remain operational even if the control plane CAPWAP tunnel is down because of a WAN failure to headquarters. Which operational mode must be configured on the APs?

Options:

A.

disconnected

B.

standalone

C.

lightweight

D.

connected

Question 16

An engineer is defining a new Cisco AVC profile with different rules for HR and VIP users. Both user types connect to a single SSID and authenticate by using their Active Directory credentials via Cisco ISE. The engineer wants to apply the AVC profile dynamically to the user types.

Which Cisco AV pair attribute must be applied to Cisco ISE?

Options:

A.

policy-avc-role

B.

policy-role-avc

C.

avc-profile-name

D.

role-name-avc

Question 17

A consulting engineer must migrate the APs from a Cisco 8540 WLC to a Cisco Catalyst 9800-80 WLC. As part of the migration, the engineer is advised to use a policy map as part of the configuration on the Catalyst 9800-80 WLC to mirror the platinum QoS settings on voice WLAN to accommodate CP-840 wireless phones. Which configuration must the engineer implement on the voice WLAN?

Question # 17

Question # 17

Options:

A.

Option A

B.

Option B

C.

Option C

D.

Option D

Question 18

Which QoS level is recommended for guest services?

Options:

A.

gold

B.

bronze

C.

platinum

D.

silver

Question 19

What is configured to use more than one port on the OEAP to extend the wired network?

Options:

A.

remote LAN ACL

B.

AAA override

C.

client load balancing

D.

remote LAN

Question 20

Refer to the exhibit.

A network architect configured the Cisco Catalyst 9800 Series Controller to find out information on client types in the wireless network. RADIUS profiling is enabled so that the controller forwards the information about clients to a Cisco ISE server through vendor-specific RADIUS attributes. The ISE server is not profiling any data from the controller. Which configuration must be added in the blank in the code to accomplish the profiling on the Cisco 9800 Series controller?

Question # 20

Options:

A.

aaa accounting identity acct_method start-stop group rad-group

B.

aaa accounting network acct_method start-stop group rad-group

C.

aaa accounting exec acct_method start-stop group rad-group

D.

aaa accounting commands acct_method start-stop group rad-group

Question 21

Which command set configures a Cisco Catalyst 9800 Series Wireless Controller so that the client traffic enters the network at the AP switch port?

Question # 21

Options:

A.

Option A

B.

Option B

C.

Option C

D.

Option D

Question 22

An engineer has configured Cisco Centralized Key Management for an enterprise that has remote branches. The remote offices are connected back to the data center using a VPN connection with low-bandwidth connections. The goal is to improve roaming. Which type of group must be configured?

Options:

A.

RF

B.

Cisco FlexConnect

C.

interlace

D.

AP

Question 23

All APs are receiving multicast traffic, instead of only the APs that need it. What is the cause of this problem?

Options:

A.

The multicast group includes all APs

B.

The wrong multicast address was used

C.

The multicast group is assigned the wrong VLAN

D.

Multicast IGMP snooping is not enabled

Question 24

Company XYZ recently migrated from legacy WLCs to Cisco Catalyst 9800 WLCs. According to the global standard, Internet bandwidth must be limited to 5 Mbps for each guest client. To which Cisco Catalyst 9800 WLC configuration component must the QoS requirement be added?

Options:

A.

table map

B.

service policy

C.

class map

D.

policy map

Question 25

An engineer must implement a CPU ACL that blocks web management traffic to the controller, but they also must allow guests to reach a Web Authentication Redirect page. To which IP address is guest client HTTPS traffic allowed for this to work?

Options:

A.

DNS server IP

B.

controller management IP

C.

virtual interface IP

D.

client interface IP

Question 26

What must be configured on ISE version 2.1 BYOD when using Single SSID?

Options:

A.

open authentication

B.

802.1x

C.

no authentication

D.

WPA2

Question 27

An engineer has configured the wireless controller to authenticate clients on the employee SSID against Microsoft Active Directory using PEAP authentication.

Which protocol does the controller use to communicate with the authentication server?

Options:

A.

EAP

B.

802.1X

C.

RADIUS

D.

WPA2

Question 28

A network engineer created a new wireless network that will be used for guest access. The corporate network must utilize all rates. The guest network must use only lower rates instead of 802.11n data rates. To what must the WMM policy of the WLAN be set to accomplish this task?

Options:

A.

required

B.

allowed

C.

disabled

D.

mandatory

Question 29

An engineer is configuring multicast for two WLCs. The controllers are in different physical locations and each handles around 500 wireless clients. How should the CAPWAP multicast group address be assigned during configuration?

Options:

A.

Each WLC must be assigned a unique multicast group address.

B.

Each WLC management address must be in the same multicast group.

C.

Both WLCs must be assigned the same multicast group address.

D.

Each WLC management address must be in a different multicast group.

Question 30

A wireless engineer deployed all remote sites as FlexConnect. The client VLAN assignment on these sites is configured manually mapped by WLAN and using local switching. Dynamic VLAN assignment is provided by the newly deployed Cisco ISE. Which IETF attribute must be configured on the AAA server to send that VLAN ID?

Options:

A.

Tunnel-Medium-Type

B.

Tunnel-Client-Endpoint

C.

Tunnel-Assignment-ID

D.

Tunnel-Private-Group-ID

Question 31

A company has a Cisco wireless network with Cisco ISE. The company wants to allow employees to use their personal mobile devices on the wireless network. The company wants to allow access to the network only if the devices meet certain criteria. To meet the requirement, the company asked a network engineer to create a native supplicant profile. Which two fields must be configured when the profile is created? (Choose two.)

Options:

A.

Allowed Protocol (PEAP/TLS)

B.

Allowed Protocol (Ms-CHAPv2/ EAP-FAST)

C.

SSID Name

D.

WLC Name

E.

Allowed Protocol (LEAP/ EAP-TTLS)

Page: 1 / 11
Total 105 questions